TSOC_GROVEY_I2CHUB : I2C Hub/Switch

TSOC_GROVEY_I2CHUB is a four(4) port I2C Hub/Switch board, an Embedded Module for thingSoC. The TSOC_GROVEY_I2CHUB allows you to connect thingSoC, Mikrobus, and/or Grove System Modules all at the same time, with any processor module. This gives you maximum flexiblity for sensor and actuator selection, and reuse. The TSOC_GROVEY_I2CHUB can operate at either 3.3V or 5V, and can also level translate 3.3V processor I2C bus to 5V peripherals when needed.

The thingSoC "Grovey Series" were designed as "Everyday Electronics", a no-frills, low cost, approach to modular embedded product design. thingSoC boards are similar in size to most break-out-boards (BOBs), but feature a standardized stacking pinout, as well as an I2C metadata store (EEPROM) to indicate what peripherals are installed.

TSOC_GROVEY_I2CHUB - Embedded Module :

The TSOC_GROVEY_I2CHUB can be configured as either a 3.3 Volt or 5.0 Volt I2C Master.

• Supported by the Arduino IDE
• thingSoC Compliant Module
• Mikrobus Compatible Module

Example Applications :

Example Sensor Applications :

• Modbus Weather Sensor BOSCH BME280 Temp, Humidity, Air Pressure

Project Status :

• 11/01/2016 : Rev. 2.0 model and layout completed.